When autocomplete results are available use up and down arrows to review and enter to select. Touch device users, explore by touch or with swipe gestures.

DIY Cat Scratcher

Choose board
Save
1686

DIY Cat Scratcher

Published on May 20, 2022
Tastemade avatar link
8.2M followers
Difficulty: Expert
Supplies:
    • Square wooden base 20x20cm
    • 3M spray glue
    • 20x20cm rug
    • Sisal twine or jute rope 8mm-30 meters long, yellow/pink/orange
    • 6mm long wood screws
    • Nails
    • Drill
    • 6mm wood wick
    • Protective glasses
    • Scissor
    • Cutter
    • Screwdriver
    • Stapler
    • Hammer
    • Pencil
    • Ruler
    Instructions:
      • Mark the center of the board with a pencil and ruler marking the diagonals.
      • Place the post in the middle and mark with a pencil.
      • Mark four points to make the holes and drill holes, wearing protective glasses.
      • Glue the base of the post and glue it to the base.
      • Let dry.
      • Cut with a cutter a 4x4 square in the center of the rug.
      • Carefully slide the rug over the post and spray the rug backing and wood with the glue.
      • Paste each other.
      • Screw the base of madra with the post through the holes already made.
      • Glue the beginning of the thread with glue and staple.
      • Hammer clamp to fit.
      • Go up with the thread to the top, very tight.
      • Place nails every 3 turns of thread.
      • Cut a 4x4cm square of carpet to place with glue at the end of the post.

      Comments

      More like this