Stephan Utama
Ide lain dari Stephan
Shop Made Tools - Page 70

Shop Made Tools - Page 70

Tailstock Tap and Die Holder by Allan Dobler -- Homemade tailstock tap and die holder fabricated from drill rod and cold rolled steel. Arbor is intended to accommodate modified commercial tap wrenches. http://www.homemadetools.net/homemade-tailstock-tap-and-die-holder

Tailstock Tap and Die Holder by Allan Dobler -- Homemade tailstock tap and die holder fabricated from drill rod and cold rolled steel. Arbor is intended to accommodate modified commercial tap wrenches. http://www.homemadetools.net/homemade-tailstock-tap-and-die-holder

Lathe Tail Stock Tap Die Holder

Lathe Tail Stock Tap Die Holder

Tap 1.jpg;  800 x 1259 (@32%)

Tap 1.jpg; 800 x 1259 (@32%)

HomeShopTech

HomeShopTech

Shop Made Tools - Page 199 Rear Toolpost from spare aloris

Shop Made Tools - Page 199 Rear Toolpost from spare aloris

Hand Tapper by rossbotics -- I built this little tapper for the sole purpose of tapping a hole at 90 deg. Everyone knows how easy it is to tap a hole by eye and be a little out of perpendicular, I don't do a lot of hand tapping but this will take the guess work out , Most of the holes I tap (about 90%) are drilled and tapped in the mill or lathe. I put a 0-3/8" Jacobs chuck on the spindle to accommodate taps up to 3/8" but I seriously doubt I tap anything larger than a #10, In fact I…

Hand Tapper by rossbotics -- I built this little tapper for the sole purpose of tapping a hole at 90 deg. Everyone knows how easy it is to tap a hole by eye and be a little out of perpendicular, I don't do a lot of hand tapping but this will take the guess work out , Most of the holes I tap (about 90%) are drilled and tapped in the mill or lathe. I put a 0-3/8" Jacobs chuck on the spindle to accommodate taps up to 3/8" but I seriously doubt I tap anything larger than a #10, In fact I…

Drill  /Tap Holder for Press-It / Sensi-Press

Drill /Tap Holder for Press-It / Sensi-Press

beautiful mechanisms

beautiful mechanisms

1950s Craftsman Garage retro remodel - Page 139 - The Garage Journal Board

1950s Craftsman Garage retro remodel - Page 139 - The Garage Journal Board